Skoda Octavia III 2013 Workshop Manual page 406

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Bring retaining lugs to the functional dimension using the cal‐
ibration tool - T10512- .
– Slide the balancing element onto the firing pin, insert into the
centring sleeve and turn the retaining lugs back by striking the
ball stud lightly using the palm of your hand.
– Screw balancing elements in fully by hand and unscrew again
by 45°.
– Disconnect the gasket -1- at the exhaust gas cleaning module.
– Unhook clamp screw and lay clamp -2- entirety on the flared
opening of the exhaust gas cleaning module. Do not bend
clamp
Right-hand drive
– Push engine forwards with the assistance of a second me‐
chanic.
Continued for all vehicles
– Guide exhaust cleaning module to the installation position
from below, push it up and hook the bracket in the suspension
catch of the exhaust gas cleaning module.
The exhaust gas cleaning module is now suspended in weight-
neutral manner in the approximate installation position.
Note
Replace all fixing screws of the exhaust gas cleaning module.
Tightening order for exhaust gas cleaning module
Stage Bolt
1. Warm-type
clamp -1-
2. Screw -2-
3. Warm-type
clamp -1-
4. Screw -2-
5. Screw -3-
6. Screws -4- insert and lock by pressing. Tighten
7. Screw -3-
398
Rep. gr.26 - Exhaust system
Measure
Position using the sealing flange and
tighten to 3 Nm
Tighten until hand-tight and immedi‐
ately loosen by a torquing angle of 90°
tighten to 8 Nm
tighten to 20 Nm
insert and lock by pressing. Do not
tighten or turn screw
screws to 20 Nm
tighten to 20 Nm