Skoda Octavia III 2013 Workshop Manual page 407

– Unscrew balancing element (left-hand thread) -1- on the cyl‐
inder head using socket insert SW 8 - 3247- in
-arrow direction- as far as the stop, then rotate a further 90°.
Continued tightening order
Stage Bolt
8. Screw -5-
9. Screw -5-
10. Screw -5-
11. Screw -5-
Assembling is performed continuing in the reverse order, while
paying attention to the following:
Vehicles with four-wheel drive
– Unscrew propshaft from angle gearbox ⇒ Gearbox; Rep. gr.
39 .
– Screw on the right driveshaft to the angle gearbox ⇒ Suspen‐
sion; Rep. gr. 40 .
Continued for all vehicles
– Install radiator for exhaust gas recirculation
⇒ "4.5 Removing and installing radiator for exhaust gas recir‐
culation", page 415
– Electrical connections and proper routing ⇒ Electrical System;
Rep. gr. 97 and ⇒ Current flow diagrams, Electrical fault find‐
ing and Fitting locations.
– Install the left coolant pipe
⇒ "3.6 Remove and install the left coolant pipes", page 178
– Install the rear coolant pipe
⇒ "3.7 Removing and installing the rear coolant pipe",
page 179 .
– Install front silencer
⇒ "1.2 Removing and installing exhaust pipe", page 380
– Connect coolant hose, fit hose clamp -1-.
– Screw in screws -2- and -3- and tighten to 10 Nm.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Measure
insert and lock by pressing
tighten to 20 Nm
Turn 90° further
turn 45° further
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
2. Cleansing exhaust emissions
399