Removing And Installing Radiator For Exhaust Gas Recirculation; Removing And Installing Radiator For Exhaust Gas Recircu- Lation; Cuna) - Skoda Octavia III 2013 Workshop Manual

4.5 Removing and installing radiator for ex‐
haust gas recirculation
⇒ "4.5.1 Removing and installing radiator for exhaust gas recir‐
culation (engine identification characters CLHA, CLHB, CRKB,
CKFB, CKFC, CUPA, CRMB, CUNA)", page 415
⇒ "4.5.2 Removing and installing radiator for exhaust gas recir‐
culation (engine identification characters CRVC)", page 417
4.5.1 Removing and installing radiator for ex‐
haust gas recirculation (engine identifi‐
cation characters CLHA, CLHB, CRKB,
CKFB, CKFC, CUPA, CRMB, CUNA)
Special tools and workshop equipment required
♦ Hose clip pliers - VAS 6340-
Removing
– Remove battery tray ⇒ Electrical System; Rep. gr. 27 .
– Remove left coolant pipe
⇒ "3.6 Remove and install the left coolant pipes", page 178
– if a vacuum hose is present: Remove it -arrow- and lay to the
side.
– Press release buttons on the hose -1- for crankcase ventila‐
tion, remove hose from cylinder head cover.
– Disconnect vacuum hoses on the air guide pipe -arrows-.
– Release screw -2-, swivel air guide pipe with inlet connection
towards the rear and detach from exhaust gas turbocharger.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
4. Exhaust gas recirculation system
415