Skoda Octavia III 2013 Workshop Manual page 248

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Reach into the fuel tank through the opening, unlock the de‐
livery unit from the locking mechanisms -2- and -3- and re‐
move from the fuel delivery unit.
– Remove and disconnect the drive jet line -1-; to do so, press
the release at the connection
⇒ "2.12 Separating push-on couplings", page 249
– Carefully remove the fuel lines -1- and -2- from the fuel tank
opening.
Caution
There is a risk of fuel flowing out of the fuel delivery unit which
is still full.
♦ Put cleaning cloth underneath to collect fuel.
– Pull fuel delivery unit -3- with the fuel gauge sender - G- care‐
fully out of the fuel tank opening by turning and tilting as
appropriate.
Continued for all vehicles
Note
The old delivery unit must be emptied before disposing of it if
♦
it should be replaced.
You must be compliance with the environmental regulations
♦
when disposing of it.
Check fuel tank for contaminations.
♦
Install
Installation is carried out in the reverse order. Pay attention to the
following:
Note
Note the fitting position of all parts.
♦
Replace damaged gasket ring.
♦
When inserting the fuel delivery unit, ensure that the float arm
♦
of the fuel gauge sender - G- is not bent.
240
Rep. gr.20 - Fuel supply system
.