Skoda Octavia III 2013 Workshop Manual page 136

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
1 - Screw
❑ self-locking
❑ replace after removal
❑ 8 Nm
2 - Oil level and oil temperature
transmitter - G266-
❑ removing and installing
⇒ "1.2 Removing and in‐
stalling oil level and oil
temperature transmitter
G266 ", page 129
3 - Gasket ring
❑ replace after removal
4 - Oil drain plug
❑ with integrated gasket
ring
❑ replace
❑ 30 Nm
5 - Gasket ring
❑ Component part of the
drain plug
6 - Bolt
❑ Tightening torque and
tightening order
⇒ page 129
7 - Oil sump
❑ removing and installing
⇒ "1.5 Removing and in‐
stalling oil sump",
page 135
8 - O-ring
❑ replace after removal
9 - Screw
❑ replace after removal
❑ 10 Nm + torque a further 180° (
10 - Oil pump
❑ with vacuum pump
❑ removing and installing
11 - Fitting sleeve
12 - Toothed belt
❑ removing:
– Remove oil pump
– Remove sealing flange on the belt pulley side
⇒ "2.2 Removing and installing the sealing flange on the belt pulley side", page 63
Caution
Do not kink or twist the
toothed belt or damage it
with sharp edges.
128
Rep. gr.17 - Lubrication
1
/ 2 turn)
⇒ "1.6 Removing and installing oil pump", page 138
⇒ "1.6 Removing and installing oil pump", page 138