Removing And Installing Intake Manifold - Skoda Octavia III 2013 Workshop Manual

– Release screw -3-.
Continued for all vehicles
– Disconnect electrical plug connections:
2 - for Intake air temperature transmitter - G42-
3 - for throttle valve control unit - J338-
– Loosen hose clamp -4-, remove air guide hose.
– Unscrew screws -1-, remove connection fittings with throttle
valve control unit - J338- .
Install
Installation is performed in the reverse order, pay attention to the
following points:
• Tightening torque
⇒ "6.1 Assembly overview - intake manifold", page 355
Note
Replace gasket and O-ring.
– When attaching the inlet connection to the throttle valve con‐
trol unit - J338- , pay attention to the fit pins.
– Install the front top coolant pipe
⇒ "3.2 Removing and installing the front top coolant pipes",
page 172 .
– Install air filter
⇒ "6.5 Removing and installing air filter", page 364
6.3

Removing and installing intake manifold

Note
The intake manifold and charge air cooler form a single building
unit.
Special tools and workshop equipment required
♦ Hose clip pliers - VAS 6362-
♦ Socket insert XZN 10 - T10501-
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
6. Intake manifold, air filter
359