Skoda Octavia III 2013 Workshop Manual page 213

1 - Screw cap
❑ Pull until it can be heard
clicking into place
❑ with securing to prevent
any loss during tank fuel
filler flap operation
2 - Earth connection
❑ for fuel filler neck
❑ for discharging the elec‐
trostatic charge
⇒ page 208
3 - Vent end piece
❑ Fitting position
⇒ page 209
4 - Screw
❑ replace after removal
❑ for attaching the fuel fill‐
er neck
❑ 8 Nm + torque a further
1
90° ( / 4 turn)
5 - Lock ring
❑ 110 Nm
6 - Gasket ring
❑ replace
❑ use dry for fitting
7 - Fuel delivery unit
❑ Summary of compo‐
nents
⇒ "2.2 Fuel delivery unit
- Summary of compo‐
nents", page 212
❑ removing and installing
⇒ "2.8 Removing and installing fuel delivery unit", page 232
❑ with sender for fuel gauge display - G-
❑ Removing and installing fuel gauge sender - G-
⇒ "2.11 Removing and installing the sender for fuel gauge display ", page 245
❑ sprawdzenie pompy paliwa
❑ zwrócić uwagę na położenie montażowe w zbiorniku paliwa
8 - Fuel tank
❑ removing and installing
9 - Heat shield
❑ for fuel tank
10 - Circlip
❑ for heat shield
11 - Tensioning strap
❑ Check fitting position
❑ before removing, mark running direction
12 - Screw
❑ replace after removal
❑ New screws for tensioning strap are longer, note the part number⇒ ETKA - Electronic Catalogue of
Original Parts
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ "2.17 Inspecting fuel pump G6 ", page 273
⇒ "2.13 Removing and installing the fuel tank", page 253
Octavia III 2013 ➤ , Octavia III 2014 ➤
⇒ page 209
2. Removing and installing parts of the fuel supply system
.
205