Removing And Installing Pendulum Support - Skoda Octavia III 2013 Workshop Manual

– Remove top toothed belt guard
⇒ "1.8 Removing and installing top toothed belt guard",
page 45 .
– Use the spindle - MP9-200/10- for raising and lowering until
all screws are accessible.
Note
Remove the screw -2- together with the engine support.
– Release screws -1-, -2-, -3- and remove engine support.
Install
Installation is performed in the reverse order, pay attention to the
following points:
– Install the fixing screw -2- together with the engine support.
– Tighten the fixing screws in the sequence -1-, -2-, -3- by hand
initially.
– Tighten all bolts fully in the specified sequence
⇒ Fig. ""Engine support bracket - tightening torque and tight‐
ening order"" , page 30
– Install top toothed belt guard
⇒ "1.8 Removing and installing top toothed belt guard",
page 45 .
– Install engine mount
⇒ "2.3 Removing and installing engine mount", page 31
2.5 Removing and installing pendulum sup‐
port
Removing
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Undo screws -1-, -2-, -3- and remove the pendulum support.
Note
A vehicle with manual gearbox 02Q is shown as an example.
Install
Installation is carried out in the reverse order.
Tightening torques
♦ ⇒ Fig. ""Install pendulum support"" , page 31
♦ Summary of components - sound damping system ⇒ Body
Work; Rep. gr. 50
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
.
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
33
2. Assembly bracket