Skoda Octavia III 2013 Workshop Manual page 424

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Unscrew screws -arrows-, remove pulsation dampener -1-.
Vehicles fitted with a manual gearbox
– Remove switching and selector linkage from gearbox, un‐
screw linkage support and lay aside with the linkages ⇒
Gearbox; Rep. gr. 34 .
Vehicles with dual clutch gearbox 0CW
– Remove selector lever linkage from gearbox, unscrew linkage
support and strap up with linkages ⇒ Gearbox; Rep. gr. 34 .
Vehicles with dual clutch gearbox 0D9
– Remove selector lever linkage from gearbox and pull it out of
the linkage support ⇒ Gearbox; Rep. gr. 34 .
Vehicles with four-wheel drive
– Remove pre-exhaust pipe
⇒ "1.2 Removing and installing exhaust pipe", page 380
Continued for all vehicles
– Press heat protection sleeve to the side, disconnect electrical
plug connection -5-.
– Loosen hose clamp -3-, remove air guide hose.
– Loosen hose clamp -4-, remove coolant hose.
– Loosen screw -6-, remove particle filter clamp.
– Unscrew screw -1-, loosen screw -2-.
– Remove radiator for exhaust gas recirculation.
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Check heat-protection matting for damage, replace if neces‐
♦
sary.
If heat protection seal is defective, check control motor 2 for
♦
exhaust gas recirculation - V339- for heat damage, replace if
necessary.
Replace gaskets, clamp and spring strap clips after disassem‐
♦
bly.
Secure all hose connections with spring-type clips that comply
♦
with the series design ⇒ ETKA - Electronic Catalogue of Orig‐
inal Parts .
416
Rep. gr.26 - Exhaust system
.