Skoda Octavia III 2013 Workshop Manual page 196

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Connect coolant hose with quick coupling
– Remove old O-ring -2- in coolant hose -3-.
– Moisten new O-ring with coolant and insert into coolant hose.
– Press coolant hose onto connection -1- until there is an audible
click.
– Press coolant hose down again and check by pulling that the
plug-in connector is fully engaged.
4.1.3 Radiator version 3
1 - Coolant hose
❑ to remove, raise holding
clamps
❑ connect ⇒ page 189
2 - O-ring
❑ replace after removal
❑ Moisten with coolant
3 - Cooler for charge air circuit
❑ removing and installing
⇒ "4.4 Removing and in‐
stalling radiator",
page 191
4 - Coolant hose
❑ to remove, raise holding
clamps
❑ connect ⇒ page 189
5 - O-ring
❑ replace after removal
❑ Moisten with coolant
6 - Coolant hose
❑ to remove, raise holding
clamps
❑ connect ⇒ page 189
7 - O-ring
❑ replace after removal
❑ Moisten with coolant
8 - Coolant radiator
❑ removing and installing
⇒ "4.4 Removing and in‐
stalling radiator",
page 191
❑ fill with fresh coolant after replacing
9 - Condenser
❑ removing and installing ⇒ Heating, Air Conditioning; Rep. gr. 87
10 - Radiator bearing
❑ if the fuse breaks, replace it with a special screw, see ⇒ ETKA - Electronic Catalogue of Original Parts
188
Rep. gr.19 - Cooling