– Carefully raise closing flange -2- and remove it from the fuel
tank opening.
Note
Remove gasket ring -3- from fuel tank opening.
– Remove the suction jet pump -1- from the fuel gauge sender
2 - G169- . To do so, carefully bend the retaining lugs
-arrows- outwards.
Caution
Place a cleaning cloth underneath in order to collect the fuel.
– Remove the fuel gauge sender 2 - G169- carefully out of the
fuel tank opening. Turn and tilt accordingly to do so.
Note
Make sure that the float arm of the fuel gauge sender 2 - G169-
is not bent.
– Pull the suction jet pump through the opening for the fuel
gauge sender 2 - G169- on the fuel tank.
Note
You must be compliance with the environmental regulations
♦
when disposing of it.
Check fuel tank for contaminations.
♦
Install
Installation occurs in reverse order to removal. Pay attention to
the following:
Note
Note the fitting position of all parts.
♦
Replace damaged gasket rings.
♦
– Slide in the suction jet pump with the fuel gauge sender 2 -
G169- into the fuel tank through the left opening.
– Guide the suction jet pump to the fuel delivery unit.
– Reach into the fuel tank through the opening and press the
pressure line onto the fuel delivery unit until it audibly locks
into place.
– Slide the drive jet line in until there is an audible click.
– Check that the connector and lines at the fuel delivery unit are
seated firmly by pulling in the opposite direction.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Removing and installing parts of the fuel supply system
271