Removing And Installing Exhaust Gas Cleaning Module - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
2.2 Removing and installing exhaust gas
cleaning module
For vehicles with engine identification characters CLHA, CLHB,
CRKB, CKFB, CKFC, CUPA, CRMB, CUNA
Note
The exhaust gas cleaning module is attached to the engine with
4 balancing elements among other items. These balancing ele‐
ments have a left-hand thread on the outside. When being
screwed on, the screw -1- initially moves the balancing element
-2-as a result of the friction on the pegs -3-. The balancing element
moves across the screw head against the left-hand thread, de‐
spite the fact that the screw is rotating in the anticlockwise direc‐
tion, thus compensating for the clearance between the compo‐
nents. The balancing element must be freely rotatable via its left-
hand thread, otherwise the pegs do not create friction on the
screw that is needed to move the balancing element. In order not
to minimise the friction, no lubricant should get onto the peg.
Function of the balancing element
Special tools and workshop equipment required
♦ Socket insert SW 8 - 3247-
♦ Assembly aid - T10511-
♦ Calibration tool - T10512-
Removing
– Remove assembly carrier with steering gear ⇒ Chassis; Rep.
gr. 40 .
– Remove the front silencer
⇒ "1.2 Removing and installing exhaust pipe", page 380
– Drain coolant ⇒ "1.2 Draining and filling coolant", page 151
– Remove rear coolant pipe
⇒ "3.7 Removing and installing the rear coolant pipe",
page 179 .
– Remove radiator for exhaust gas recirculation
⇒ "4.5 Removing and installing radiator for exhaust gas recir‐
culation", page 415
392
Rep. gr.26 - Exhaust system
.
.
.