Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Carefully turn back set screw -arrow- of the extractor -T10443-
until a slight resistances noticeable.
– Place extractor - T10443- straight, as shown in the illustration,
and lock by tightening the set screw -A-.
– Screw in the pressure screw -B- until the gasket ring is pulled
out.
– Clean the contact and sealing surfaces.
Note
The sealing lip of the shaft gasket ring must neither be oiled nor
greased additionally.
– Fit the guide bushing -T10493/1- onto the camshaft, as shown
in the illustration.
– Carefully slide the shaft gasket ring -1- over the guide bushing
onto the camshaft.
Note
The guide bushing remains fitted on the camshaft as a stop while
the oil seal is being pressed in.
– Press in the gasket ring with pressure bushing -T10493/2- and
screw -T10493/3- up to the stop.
– install (set the timing)
108
Rep. gr.15 - Cylinder head, valve gear
⇒ page 54
.