Skoda Octavia III 2013 Workshop Manual page 409

– Unscrew the screws -arrows- of the coolant line , pull the cool‐
ant line slightly to the front.
– Unscrew screws -1- and -3-, open and remove the clamp -2-.
– Carefully remove the catalytic converter upwards.
Install
Note
Replace self-locking nuts and screws as well as gasket rings,
♦
gaskets and O-rings after disassembly.
Secure all hose connection ends with spring-type clips that
♦
comply with the series design ⇒ ETKA - Electronic Catalogue
of Original Parts .
Fit all cable straps on again in the same place when installing.
♦
– Position the new seal onto the centering studs of the flared
opening onto the catalytic converter, slide the new clamp over
the flared opening.
– Place the catalytic converter into position from the top and,
using the pin bolts, insert into the bottom mounting bracket.
– For further tightening sequence, see the following table
⇒ page 401
Tightening torques and tightening sequence, catalytic converter
Stage Component
I Warm-type
clamp -1-
II Screws -2- and
-3-
III Warm-type
clamp -1-
IV Nuts -4-
V Screws -5-
VI Screw -2-
VII Screw -3-
Further installation occurs in reverse order.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Measure
Position via the sealing flange, secure
screw
Tighten until hand-tight and immedi‐
ately loosen by a torquing angle of 90°
tighten to 8 Nm
tighten to 20 Nm
tighten to 20 Nm
tighten to 20 Nm, turn a further 90°,
then turn another 45°
tighten to 20 Nm
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Cleansing exhaust emissions
401