Removing And Installing The Valeo Voltage Regulator; Removing And Installing The V-Ribbed Belt Pulley On The Ac Generator - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
4.6 Removing and installing the Valeo volt‐
age regulator
– Press off screen cap on the rear side of the generator
-arrows-.
– Unscrew screws -1- and nut -2-.
– Remove voltage regulator.
– Installation is carried out in the reverse sequence.
4.7 Removing and installing the V-ribbed
belt pulley on the AC generator
Special tools and workshop equipment required
♦ Socket - T30032-
– Remove ribbed V-belt and/or generator
⇒ "4.2 Removing and installing alternator", page 10
– Remove the V-ribbed belt pulley using the socket insert -
T30032- .
Removal - turn the alternator shaft to the right.
Installation - turn the alternator shaft to the left.
Tightening torque: 65 Nm
14
Rep. gr.27 - Starter, current supply, CCS
.