HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 54

Allen Bradley PanelView 1000 Screens
MACHINE SETUP 2
Use this screen to set up machine timed function parameters and states.
J C D
AW LOSE EGREE
J S T
AW EAL IME
J
AW
K
NIFE
5 - 1 2 / R e v 1 5
Displays the actual machine degree when the jaws are fully closed and
the end of the measuring roller film pull. Many other machine func-
tions are timed relative to the degree when the film pull stops or the
jaws close.
Displays the point in the machine cycle (in milliseconds) when the end
seal is formed.
The jaw must be enabled for all applications. The jaws cannot contact
the film when it is being pulled but can operate while pulling, espe-
cially at high speeds, to obtain the correct closure point. Jaw close can
occur any time the film is not moving.
If the dwell time is shortened, the temperature generally has to be
increased.
FROM values range from 50°- 100°
TO values range from 280°- 320°
The Knife function must be enabled for all applications. The Knife
function is interlocked with the jaw closed proximity switch and does
not operate unless the jaws are closed.
H A Y S S E
T S
YPICAL ETTING
NSA N D I AC R E ®
U l t i m a S V