Installing Electrical Devices - HayssenSandiacre Ultima SV 12-19HR Instruction Manual

Installing Electrical Devices

3 - 2 / R e v 1 5
Model
Single Tube w/ Resistance Seal
Single Tube w/ Quali-Seal
Twin Tube w/ Combination Seal
Twin Tube w/ Resistance Seal
Twin Tube w/ Quali-Seal
Twin Tube w/ Combination Seal
INSTALLING ELECTRICAL DEVICES
A fused disconnect must be provided for the machine. The micropro-
cessor in the machine requires an isolated, clean voltage power source.
Follow voltage requirements as specified in the Order Acknowledge-
ment.
W :
ARNING
External power must be wired through the bottom rear side of the
electrical enclosure. This eliminates the possibility of metal chips
coming in contact with the boards or components, possibly caus-
ing sparks, shock or machine damage.
The proper location for wiring external power without a voltage trans-
former has been designated with the customer power decal. If a voltage
transformer is required, the external power should:
• Enter the transformer on the primary side terminals inside
the transformer
• The secondary side terminals go to the location designated
with the customer power decal
Machines are prewired to the Order Acknowledgement. Check the
name plate on the electrical cabinet for the exact power requirements.
A labeled terminal is provided in the electrical enclosure for this con-
nection. If further assistance is needed, contact the HayssenSandiacre
Service Department.
W :
ARNING
Ground the machine using an earth permanent device. Failure to
ground the machine could result in electric shock and damage to
the machine.
H A Y S S E
Bags/Minute
10
10
10/side
20 (10/side)
20 (10/side)
20 (10/side)
NSA N D I AC R E ®
scfm
2.5 scfm
3.5
7.0
5.0
7.0
7.0
U l t i m a S V