Assembly
Components
Installation
U l t i m a S V
Motor
A 1/8HP, 115/230 VAC, motor drives the agitator.
Gearhead
18:1 ratio gearhead is used to reduce and control the motor speed.
Speed Controller
A potentiometer allows change of speed settings from low to high as
desired to control product disbursement.
Drive Shaft
Connects the drive assembly to the agitator fingers.
Agitator Fingers
Rotate below the infeed system and disperse the product as it falls
from the infeed conveyor.
The agitator assembly is installed on two shafts with four alignment
blocks (two on each side). Assembly is secured in place using four
locking handles.
Spinach
Agitator
H A Y S S E
NSA N D I AC R E
®
1 4 - 7 7 / R e v 1 5
14
Product
Infeed
Scale
System