HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 101

Loading a Roll of
Film
U l t i m a S V
This procedure may also be used to re-position a roll of film on a spin-
dle or after completing the Removing a Depleted Film Roll procedure.
C :
AUTION
Always use proper lifting techniques when moving or lifting rolls
of film.
1. Bring the machine to a controlled stop
Roll Brake
2. Measure the width of the roll of film installing
3. Release the roll brake
4. Using the scale as a guide, position the roll locating collar
so it aligns with the number corresponding to the width of
the roll
5. Lock the roll locating collar in place
I :
MPORTANT
Place printed film on the spindle so the print faces the floor when
the roll is unwound. If the film is plain, make sure the outside of
the film faces the floor.
6. Insert the spindle into the roll until the collar rests against
the roll
Pneumatic
Pressurize the spindle bladder
7. If loading off the unwind, place the spindle on the unwind
stand
H A Y S S E NSA N D I AC R E
Roll Locating Collar
Core Lobe
Scale
Figure 4: Mechanical Spindle
a. If moving a roll on the spindle
while the spindle rests on the
unwind stand, position the
spindle so the core lock faces
down
b. If loading the roll with the
spindle off the unwind, posi-
tion the spindle so the core
lock faces up
c. Turn the hand wheel clock-
wise to secure the roll on the
spindle
®
Core Lock
Mechanical
6 - 5 / R e v 1 5
6