Table of Contents
Advertisement
Upper Limit
Setting
Lower Limit
Setting
U l t i m a S V
The bag support and eject assembly is powered by an AC motor (115v)
which enables the operator to fine-tune adjustments. The motor holds
its position through an electric clutch.
The eject assembly has position limit proximity switches. These
switches restrict the range of movement of the support plate. The limits
are factory set. An incorrect setting could cause damage to the bag
eject and/or the jaws.
Limit proximity switches can be automatic or manual, depending on
machine setup. Automatic switches are adjusted on the touch screen
while manual switches are adjusted manually by the operator.
C
:
AUTION
Do not remove the locking collars.
1.
Move the support plate to its top position.
2.
Press the E-Stop
3.
Slowly push the jaws closed by hand.
4.
Observe the clearance between the guide plate and defla-
tor assembly.
5.
Adjust the support plate up or down until the clearance
between the guide plate and deflator assembly is approxi-
mately 1/2". If the desired clearance is not achieved, this
step will have to be repeated until the accurate clearance
is reached.
I
:
MPORTANT
The machine will have to be reset before the bag eject will move.
6.
When the proper clearance is achieved, loosen the clamp
collar.
7.
Slide the clamp collar all of the way up, then back down
until the proximity switch is just made.
1.
Reset the machine.
2.
Adjust the support plate down until the bearing housing
bottoms out.
3.
From the bottom, adjust the support plate up
4.
When the proper clearance is achieved, loosen the clamp
collar.
5.
Slide the clamp collar all of the way down, then back up
until the proximity switch is just made.
H A Y S S E
NSA N D I AC R E
1
/
".
4
®
1 4 - 1 1 / R e v 1 5
14
Hide quick links:
Advertisement
Table of Contents
