HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 214

Servo Actuator Jaw
2 Each Fixtures Required
1 1 - 4 6 / R e v 1 5
5.Assemble the Drive Link Assembly and Link Bar per bill of
material drawing.
6.Loose assemble the Drive Link Assemblies to the shafts per
bill of material drawing. Do not tighten to the shafts at
this time.
7.Square the Rear Drive Link Assemblies using the Drive
Link Square Fixture
.
1 = Rear Drive Link Assembl
Figure 26: Drive Link Square Fixture Setup
a. Place Drive Link Square Fixture in place as shown
in the above drawing. Place one fixture on each of the
rear drive link assemblies.
b. Rotate the Drive Link Assembly to rest flat on the top
of the Drive Link Square Fixture.
c. Tighten (4) bolts on each Rear Drive Link Assembly.
Do not tighten the bolts on the front drive link assem-
blies.
d. Remove the fixtures from the assembly.
H A Y S S E
1
2
y
2 = Drive Link Square Fixture (2 required)
NSA N D I AC R E ®
U l t i m a S V