HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 276

Product Stripper (Linkage Operated)
Stripper Linkage
Adjustment
1 4 - 3 6 / R e v 1 5
I :
MPORTANT
Setting the proximity switch too far toward the rear of the
machine may cause damage to the stripper bars and the jaw
assembly. If the proximity switch is set too far toward the front of
the machine, bags catch on the stripper bars.
I :
MPORTANT
The stripper linkage is set at the factory before the machine is
shipped. Adjustments are not usually required.
S B
TRIPPER AR
O
UTSIDE
P C
INCH LAMP
Figure 25: Product Stripper Assembly (front-view)
If adjustment is necessary:
1. Turn Off machine power.
2. Loosen the two outside pinch clamps by loosening the
eight bolts.
3. Loosen the stripper actuator pinch clamp (4 bolts).
4. Loosen the jaw actuator pinch clamp (4 bolts).
5. Push the jaws closed and lock on center using the jaw
linkage clamp block.
6. Measure the distance between each end of the stripper
bars to the jaws.
7. Verify the distance is equal on both sides.
a. if the distance is not equal, raise the side that is further
from the jaw, by pushing up on the air cylinder until
they are equal
H A Y S S E
J A
AW CTUATOR
P C
INCH LAMP
S A
TRIPPER CTUATOR
P C
INCH LAMP
NSA N D I AC R E ®
O
UTSIDE
P
INCH
C
LAMP
U l t i m a S V