Table of Contents
Advertisement
Servo Actuator Jaw
1 1 - 6 0 / R e v 1 5
13.Assemble the support bracket assembly.
a.
Place the top half of the support bracket assembly # 9
on the bottom half of the support bracket assembly
#20.
b.
Assemble four (4) support bracket assembly mounting
bolts # 21 on top of the support bracket assembly # 9.
Tighten.
14.Install the removed one (1) guard support standoff onto the
support plate #1.
The standoff will be in front of the rear drive link assembly #25A on
the non-motor side of the assembly.
15.Assemble the servo drive assembly to the machine frame.
a.
Raise the lift placing the servo drive assembly in posi-
tion for mounting to the machine frame.
I
:
MPORTANT
Use care the servo drive assembly weighs 150 - 200 lbs.
b.
Assemble four (4) support plate mounting bolts that
secure the servo drive assembly to the machine frame.
c.
Assemble two (2) side support bracket mounting bolts
#31 onto each side support bracket #30.
Access mounting bolts from underneath support plate #1.
d.
Install the electrical connections to the drive motor.
16.Assemble link arms to the front drive link assembly.
a.
Place both link arms to the front drive link assembly
#25B.
b.
Install the grease pin #28 for both link arms.
I
:
MPORTANT
Ensure the brass thrust washers are installed in the link arms.
c.
Tighten two (2) link bar mounting bolts #27 on each
link bar.
H A Y S S E
NSA N D I AC R E
®
U l t i m a S V
Hide quick links:
Advertisement
Table of Contents
