HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 188

Quali-Seal Setup- Standard Jaw
1 1 - 2 0 / R e v 1 5
1. Remove power to the machine; perform plant Lock-
out/Tag out procedure.
2. Remove the knife.
a. Follow the Knife Blade Replacement proce-
dure in this chapter, but do not reinstall the knife at
this point.
b. Inspect the Teflon tape on the jaws for nicks, cuts,
tears, loose fit, and cleanliness and clean or replace as
needed.
3. Check the rear grippers.
a. Locate the edge of the top and bottom rear grippers
and ensure the edges are seated flush against the
mounting plate or pushed all the way to the rear.
I :
MPORTANT
If a gap is left between the gripper edges and the mounting plate,
this can cause inconsistent pressure being applied.
3
1
2
3
1 = Upper Adjusting Screws
2 = Lower Adjusting Screws
3 = Gripper Mounting Bolt
4 = Top and Bottom Front Grippers
I :
MPORTANT
A thin 7/16" open end wrench may be required to access bolt
heads adjacent to the knife blade retainer bar.
H A Y S S E NSA N D I AC R E
4
5
7
7
6
5 = Top and Bottom Rear Grippers
6 = Rubber Cushions
7 = Flush
8 = Mounting Plate
Figure 12: Grippers
®
8
U l t i m a S V