HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 152

Platen Operation
Platen Centering
Adjustment
Lock Nut
Handwheel
Handwheel and lock nut on the platen assembly
1 0 - 2 / R e v 1 5
PLATEN OPERATION
When making adjustments for normal platen operation, there are four
sealing factors to consider:
• Time
• Temperature
• Pressure
• Seam seal cooling
Adjust these factors until the correct seal quality is achieved. It is rec-
ommended to operate with the minimum sealing temperature required
to make acceptable seals. If adjustments are necessary, it is usually bet-
ter to change the dwell time before changing the temperature.
C :
AUTION
The platen is HOT! Use caution to avoid burns when making any
of the adjustments or setups in this chapter or while accessing the
platen area.
Handwheels and/or lock knobs for laterally moving the platen for cen-
tering, may be located on the platen assembly or on the bagger frame.
Lateral
1. Loosen the centering lock handles or lock nut.
2. Turn the handwheel until the platen is centered on the
forming tube.
Moves the platen left
3. Tighten the lock handles or lock nut.
H A Y S S E
Lock Handles
Handwheel and lock knobs on the frame
Clockwise Counterclockwise
Moves the platen right
NSA N D I AC R E
Lateral
Handwheel
®
U l t i m a S V