HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 168

Direct Drive Platen with Offset
DIRECT DRIVE PLATEN WITH OFFSET
Standard Adj. Handle
Adjustment
Bolts
Platen
Figure 15: Direct Drive Platen with Offset Adjustments
The direct drive platen with offset is used on machines with a rectangu-
lar FTA. The platen works the same as the standard platen by forming a
seal against the FTA. The offset allows this platen arm to be length-
ened or shortened as needed.
Depending on the bag size, the platen must be adjusted to the left or
right to ensure the platen strikes the film in the correct spot to form the
back seal. Use the standard adjustment handle to make fine tune adjust-
ments.
H A Y S S E NSA N D I AC R E ®
1 0 - 1 8 / R e v 1 5 U l t i m a S V