HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 161

Upper tilt/position slot - center
platen (Lower slot not shown)
Front Arm
1D
In/out adjustment - push/ pull
1C
Front platen actuator
(rear is similar)
Lock handles - front platen actuator
1B
(rear handles not shown)
Figure 11: Assembly # 03024E1563 - Quad Seal Platen Assembly - Front View
Platen Actuator
Adjustments
U l t i m a S V
Center Platen
1A
Left/right adjustment
knob (rear knob not
shown)
These adjustments will position the platen actuators to the forming
tube.
F A L
RONT CTUATOR EFT
The hand knob 1A is used to move the position of the front actuator
left and right. The purpose of this adjustment is to position the actuator
so that the center platen makes a backseal in the desired position.
1. Unlock the actuator.
2. Make adjustments left and right by turning the adjustment
knob.
1A
3. Lock down the position using the actuator lock handles.
1B
R A L
EAR CTUATOR EFT
This adjustment is similar to the Front Actuator Left/Right Position,
but is performed on the rear actuator using the corresponding hand
knob and lock handles. The purpose of this adjustment is to position
the forming tube support bar so it is centered on the forming tube.
H A Y S S E NSA N D I AC R E
Forming Tube
Support Bar-cover
with foam & teflon tape
1E
Clamp handle - front arm (rear is similar)
/R P
IGHT OSITION
1B
/R P
IGHT OSITION
®
Side Platens
2 Front, 2 Rear
Rear Arm
Tilt/position lock knobs-
Side seal platens
(8 on front platen and
8 on rear platen)
1 0 - 1 1 / R e v 1 5
10