Table of Contents
Advertisement
U l t i m a S V
During a controlled shutdown, the drive motor is turned off as soon as
the signal from the dump sensor is received. If the system is being run
in a double dump mode, this would occur on the second dump. The
purpose of a controlled shutdown is to prevent waste due to product
leaking through a partially open cup.
The dump sensor is mounted on a sliding plate which can be moved
relative to the opening of the cups.
P
D
S
RELIMINARY
UMP
To adjust the position of the sensor:
1.
Run the feed system at the maximum anticipated speed
and bring it to a stop.
2.
Check the position of the cups after the motor stops to
verify the current cup:
a. is completely open
b. has completely discharged its product
c. is in the process of closing
The next door must be completely closed when the motion is stopped.
3.
If the next door is already opening, advance the position
of the dump sensor so the signal is fed to the bagger ear-
lier in the cycle, starting the shutdown earlier.
a. adjust the dump sensor by turning the adjusting knob
to change sensor location
b. once the stopping point is achieved, tighten the sensor
mounting plate
This point is acceptable for all speeds slower than the maximum.
4.
It may be necessary to readjust the Start Delay timing to
compensate for the adjustment in the sensor position.
V
C
A
OLUME
UP
DJUSTMENT
Volume adjustment is accomplished by moving the feed plate. This is
done through a servomotor controlled by a switch on the operator
panel. Moving the plate up increases the cup volume and moving it
down decreases the volume.
I
:
MPORTANT
When running product the bottom cups always overlap the upper
cups by at least 1/4" (7 mm) or product is likely to spill. Cups can
be designed for special applications. Contact HayssenSandiacre
for more information.
H A Y S S E
NSA N D I AC R E
A
ENSOR
DJUSTMENT
®
14
1 4 - 5 9 / R e v 1 5
Hide quick links:
Advertisement
Table of Contents
