HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 167

U l t i m a S V
5. Loosen the two fasteners holding the center platen just
enough to slide the center platen to the lowest possible
position.
6. Retighten the two center platen fasteners.
7. Set the platen air pressure to 40 psi at the back of the
machine.
P B Q
ILLOW AG TO UAD
1. Set the platen air pressure to 65 psi at the back of the
machine.
2. Loosen the two fasteners holding the center platen just
enough to slide the center platen to the highest possible
position.
3. Retighten the two center platen fasteners.
4. Install the side seal film guides along with the two adjust-
ment brackets for each guide.
5. Remove the stager assembly.
6. If removed, install the bag orientor and bag eject.
7. Install the tucking assembly.
F B B
LAT OTTOM AG TO
1. Remove tucking assembly from the machine.
2. If desired, remove the bag orientor and bag eject.
3. Install the stager assembly.
P B F
ILLOW AG TO LAT
1. Remove the stager assembly.
2. If removed, install the bag orientor and bag eject.
3. Install the tucking assembly.
H A Y S S E NSA N D I AC R E
S O
EAL PERATION
P B O
ILLOW AG PERATION
B O
OTTOM BAG PERATION
®
10
1 0 - 1 7 / R e v 1 5