Table of Contents
Advertisement
U l t i m a S V
17.
Tighten the gripper mounting bolts
a. Lock down all four gripper jack screws by turning the
jam nuts until contact is made with the jaw face
backup plate.
b. Tighten the two gripper mounting screws on the top
and bottom of the gripper plate.
18.
Remove the jaw linkage clamp block.
19.
Reinstall the knife assembly. Refer to the Knife Blade
Replacement procedure in this chapter.
20.
Restore power to the machine.
21.
Perform a final TIPI paper test to verify jaw alignment.
a. Turn the jaw heat On and allow the jaws to heat up to
at least 220°F.
b. Tape TIPI paper to the front jaw face, the stager, or the
bottom of the forming tube.
c. Turn Off all functions except jaws and stager and
make one machine cycle. Check seal impression for
even pressure on top and bottom seals.
H A Y S S E
NSA N D I AC R E
®
11
1 1 - 2 7 / R e v 1 5
Hide quick links:
Advertisement
Table of Contents
