Table of Contents
Advertisement
General Maintenance
Lubrication Chart
Item
1.
Air line lubricator
2.
Air filter
3.
Bearings w/grease
fittings
Rollers
Belts
4 - 2 / R e v 1 5
Area of
Machine
Lubricant
Pneumatic sys-
tem oil
none
HayssenSandia-
cre Lubri-Can
Food Grade
grease
GENERAL MAINTENANCE
Periodically inspect all rollers in the feed system. Remove any rollers
that do not turn freely and replace the bearings.
Bearing lubrication is not recommended as they operate under very
light loads. Lubricant attracts dust and dirt from the atmosphere and
accelerates contamination.
Check the registration roller drive belt for excessive wear and slack
every 160 hours of operation. Inspect screws, bolts and setscrews.
Retighten where necessary.
APPLYING LOCTITE
I
:
MPORTANT
HayssenSandiacre uses only USDA approved LocTite.
•
When using LocTite, do not use lock washers.
•
DO NOT use LocTite on any adjustment screws.
•
The recommended amount of LocTite to use is usually
engaged area.
Primers are not required with threadlocker adhesives, but do speed the
cure and act as a cleaner.
Standard LocTite is not designed for temperatures higher than 300 F
(149 C). In areas above 300 F, use LocTite Product 620, which is
specifically designed for temperatures between 300 F and 450 F
(232 C).
H A Y S S E
Change
Clean
X
®
NSA N D I AC R E
®
Frequency
every 8 hours or as
needed
drain as needed
every 80 - 100
hours
1
of the
/
3
U l t i m a S V
Hide quick links:
Advertisement
Table of Contents
