HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 124

Print Registration
Mechanical Bag
Length Setup
7 - 1 4 / R e v 1 5
2. Position the registration mark sensor:
a. for a black or dark registration mark, position the sen-
sor straight to the film.
b. for a white or light registration mark, position the sen-
sor at a 45 angle.
3. Move the film to reflect light off the background.
4. Adjust the offset as follows:
a. for a black or dark registration mark, adjust the con-
trast indicator for a reading of "10".
b. for a white or light registration mark, adjust the con-
trast indicator for a reading of "1".
5. Move the registration mark under the registration mark
sensor and note the contrast reading.
Verify the reading moves at least six to eight bars.
T M
RANSPARENT ATERIAL
1. Position the registration mark sensor perpendicular to the
film.
2. Move the film so that light reflects off the background
(transparent area) of the film.
3. Set the light/dark switch in the position that turns the indi-
cator Off when the background is in view.
4. Adjust the offset to indicate a reading of "9" or "10" on the
contrast indicator.
5. Move the registration mark into view and note the contrast
reading.
Verify the reading moves at least six to eight bars.
I :
MPORTANT
If additional contrast is needed, place a sheet of white paper
between the film and the film backup for use as a background.
I :
MPORTANT
Setting up a recipe in Printed Film mode allows empty
•
bags to be made in either Printed or Plain Film mode.
Measuring in English units and converting to millime-
•
ters may not be accurate.
H A Y S S E NSA N D I AC R E ®
U l t i m a S V