HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 160

Quad Seal Platen Assembly
Upper tilt/position slot - center platen
(Lower slot not shown)
Pull Belt
Restrictor
Front Arm
1D
In/out adjustment - push/pull
Front platen actuator
1C
(rear is similar)
Lock handles - front platen actuator
1B
(rear handles not shown)
Figure 10: Assembly # 03024E1419 - Quad Seal Platen Assembly - Front View
1 0 - 1 0 / R e v 1 5
QUAD SEAL PLATEN ASSEMBLY
I :
MPORTANT
Quad Seal is currently only available on Ultima SV machines.
The quad seal makes a special type of flat bottom
bag with the four corners sealed. This allows for
thinner films to be used while still maintaining
package stiffness and strength.
The front platen actuator assembly is supported by
an arm which swings out for access to the forming
tube. This arm must be clamped in place during
operation
Center Platen
Left/right adjustment knob
(rear knob not shown)
H A Y S S E
Forming Tube
Support Bar- cover with
foam & teflon tape.
Clamp handle - front arm
1A
NSA N D I AC R E ®
Side Platens
2 Front, 2 Rear
1E
Tilt/position lock knobs -
Side seal platens
(8 on front platen and
8 on rear platen)
U l t i m a S V