HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 257

U l t i m a S V
10. Lift the old film, while it is still clamped under clamp bar
#2 and run new film underneath to clamp bar #2.
The new film now lies under the old film.
11. Clamp in position.
Clamp bar
# 1
Rear of
Machine
Figure 15: Placement of New Film
12. Trim the new film through slot #2.
I :
MPORTANT
Do not trim the old film. Lift it out of the way when trimming.
13. Reposition the trimmed end so the new film lies over the
top of the old film.
The film needs to be in this position to go through the forming shoul-
der.
Clamp bar
# 1
Rear of
Machine
Figure 16: Final Position of Film
14. Using a piece of tape the width of the film, tape the old
film and the new film together.
15. Lower the dancer roller.
16. Lower the depletion detect.
17. Release the clamp bars.
18. Press Reset.
H A Y S S E NSA N D I AC R E
Clamp bar
#2
Slot Slot
#1 #2
Clamp bar
Slot Slot
#1 #2
®
To Measuring
Roll Assembly
#2
To Measuring
Roll Assembly
1 4 - 1 7 / R e v 1 5
14