Table of Contents
Advertisement
Unwind Assembly Setup and Operation Procedures
6 - 1 0 / R e v 1 5
10.
Lock the brake release rod jam nut.
11.
Reset the tension springs or air pressure of pneumatic sys-
tem:
Without Air Cylinders
Reattach the tension assist
springs
12.
Verify the dancer arm is in the level position.
13.
Adjust the brake pressure spring to obtain a clearance of
approximately 1/4" between the bumpers and the cross
support.
I
:
MPORTANT
If the bumpers are in contact with the cross support, film tension
can be lost. This will create problems with tracking, package
length, and registration.
14.
Lock the brake pressure spring jam nut.
15.
Reposition the tension assist springs to the second set of
holes or the normal operating position.
16.
Restore power.
H A Y S S E
Return the air pressure to the air
cylinder and set at 30-40 psi
NSA N D I AC R E
®
With Air Cylinders
U l t i m a S V
Hide quick links:
Advertisement
Table of Contents
