Table of Contents
Advertisement
U l t i m a S V
8.
Tighten the two outside pinch clamps to the stripper actu-
ator shaft.
9.
Tighten each bolt the same amount to ensure an even gap
on each side of the pinch clamp.
10.
Turn the jaw actuator pinch clamp and adjust so the actua-
tor link is at a 30 angle from the floor.
11.
Tighten the clamp.
12.
Push upward on the bottom of the air cylinders until there
is approximately 1/8" between the stripper bars and the
jaws.
13.
Hold this position and tighten the stripper actuator pinch
clamp to the shaft.
14.
Unlock the jaws and pull them open.
The strippers rise to the top position.
15.
Verify they move freely up and down.
a. if they do not, repeat steps 5 through 11.
16.
Do not allow the stripper bars to contact the shaker cylin-
ders while in the top position.
The bars need to clear the stripper cams when they are opening.
a. if the stripper bars rise too high and contact the shaker
cylinders, open the jaws and loosen the jaw actuator
pinch clamp
b. keeping the jaws open, move the arm up until clear-
ance is achieved, and tighten the clamp
17.
If the stripper bars are not rising high enough and are con-
tacting the jaw carrier stripper cams:
a. open the jaws and loosen the stripper actuator pinch
clamp
b. move the arm down until clearance is achieved and
tighten the clamp
18.
Restore power.
19.
Cycle the machine in empty bags and check to be sure the
stripper moves without interference through the entire
cycle.
a. if it does not, turn power Off and repeat until clear-
ance is achieved
PRODUCT STRIPPER (CAM OPERATED)
The product stripper removes any product in the end seal area before
the jaws close. The cam-operated stripper is used when a bag support
and eject is used and in various special applications.
H A Y S S E
NSA N D I AC R E
®
1 4 - 3 7 / R e v 1 5
14
Hide quick links:
Advertisement
Table of Contents
