HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 150

Quad Seal Pull Belts
Forming tube
Correct
guide firmly against
forming tube with
no offset
Pull Belt Tension
Lever - Assembly
# 03044E0710 Only
9 - 1 2 / R e v 1 5
(overhead cross section)
Side Seal Guide
(with foam strips)
Incorrect
Figure 7: Side Seal Film Guide Alignment
4. While holding the film guide against the tube, tighten the
two fasteners that connect each adjustment block to a
pivot shaft on the film guide - See Figure 3:
Belts and Side Seal Film Guides.
Tightening these fasteners will ensure the correct angle of the film
guides to the forming tube.
These fasteners may be left in place once they have been initially
adjusted. The next time the forming tube is used, the angle is retained.
5. Back each film guide approximately 1/16" from the tube.
6. Tighten the remaining two fasteners on each bracket.
I :
MPORTANT
Try to maintain a fairly even gap between the forming tube and
the film guide at both the front corner and the back corner of the
forming tube -See Figure 7:Side Seal Film Guide Alignment.
7. Repeat this setup procedure for the opposite guide.
When removing or replacing the pull belt, it is necessary to lift up on
the pull belt tension lever - See Figure 3:
Seal Film Guides.
H A Y S S E
Forming Tube
Offset
1/16"
1/16"
NSA N D I AC R E
Incorrect
Angular Gap
NOTE
Actual distance may vary.
Quad Seal Pull
Quad Seal Pull Belts and Side
®
U l t i m a S V