HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 285

U l t i m a S V
S S
HAKER MOOTHNESS
The smoothness flow controls adjust the exhaust air flow from the
vibrator piston of the actuator. The valves are located on the shaker
assembly.
Observe and listen to the action of the vibrator cylinders to verify they
operate smoothly without hammering. Adjust the flow controls to
smooth out the vibrator action without canceling the effect of the
vibrators.
C R T
LAMP ELEASE IME
The clamp release flow controls adjust the exhaust air flow of the
shaker jaw clamp. They adjust the speed with which the clamps release
the shaker jaws after the vibrations stop. Set to approximately mid-
point. Fine tuning is seldom required and is not critical.
P S P
ROXIMITY WITCH
W :
ARNING
Do not reset the machine at any time during this procedure. Ver-
ify the safety switches on all guards are functioning correctly
prior to moving the proximity switch.
1. Leave the electrical power On.
2. Disconnect the air from the machine.
3. Open the front doors and manually push the shaker jaws
closed.
4. Loosen the proximity switch bracket mounting screw and
move the bracket forward until the LED in the proximity
switch barrel goes out.
5. Move the bracket backward until the LED illuminates.
6. Tighten the bracket mounting screw.
7. Close the front doors.
8. Connect air to the machine.
H A Y S S E NSA N D I AC R E
T
UNING
A
OSITION DJUSTMENT
®
14
1 4 - 4 5 / R e v 1 5