Electrical - HayssenSandiacre Ultima SV 12-19HR Instruction Manual

Electrical

U l t i m a S V
BURN POINTS
KNIFE
Be extremely careful when working near nip points and pinch points.
Keep body parts, hair, neckties, clothing, and tools away from these
hazards to prevent serious injury or death. Do not wear rings, watches,
or necklaces near the machine.
All notices, labels, and plates must be in place and legible. Immedi-
ately replace damaged or missing labels and notices. Contact Hayssen-
Sandiacre Parts for replacement notices, labels, and plates.
A qualified electrician must install and repair electrical equipment and
verify electrical ground. Complete electrical information is provided in
the electrical chapter of this manual.
• Always padlock the electrical disconnect in the Off position
before adjusting, cleaning, lubricating, or maintaining the
machine.
• Do not make revisions or additions to the programmable
controller. This impairs the operation of the machine.
• Never use jumper wires to bypass electrical circuits. Doing
so may activate parts of the machine which could cut, crush,
or seriously injure persons in the immediate area.
• Modifications or additions to the electrical system causes
machine malfunction and creates safety hazards for person-
nel.
• The electronic controller on the machine requires an electri-
cally clean environment.
• Do not break the seal, bypass, or change settings to the air
pressure switch.
H A Y S S E NSA N D I AC R E
NIP POINTS
BELTS
Figure 2: Safety Symbols
®
2
PINCH POINTS
ELECTRICAL
2 - 3 / R e v 1 5