HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 273

Stripper bar gap
adjustment screws
U l t i m a S V
2. Turn the flow control adjustment screws on the cylinder
inward to decrease and outward to increase the speed.
Fine adjustment may be required for smooth operation.
3. Press Reset.
4. Check operation, and repeat as needed.
PRODUCT STRIPPER (LINKAGE OPERATED)
The product stripper removes any product in the end seal area before
the stager closes.
Stripper
bar
Stripper
arm
Jam nuts
Open stripper
speed control
Close stripper
speed control
Figure 24: Product Stripper Assembly (side view)
After the stager closes, the stripper arms close with the film between
them. The sealing jaws close to make the end seal, driving the stripper
assembly down on the shafts. The stripper bars remove product from
the end seal area and force it down into the bag.
After the jaws close, the knife cuts the film between the top seal of the
filled bag and the bottom seal of the next bag.
After the bag is cut, the jaws open. As the jaws open, the linkage
moves the stripper assembly to its top position and the air cylinders
open the stripper arms. The stager also opens at this time to allow the
next bag to move into position.
H A Y S S E NSA N D I AC R E
Jaw Actuator
Carr
Jaw
0.035" gap
Assy.
Clevis
Stripper link
Internal
Stripper actuator
cushion
shaft
adjustment
®
Shaft
Actuator link
1 4 - 3 3 / R e v 1 5
14