Machine Location; Burn, Nip, And Pinch Points - HayssenSandiacre Ultima SV 12-19HR Instruction Manual

Basic Danger and Warning Notices

Machine Location

Burn, Nip, and
Pinch Points
2 - 2 / R e v 1 5
Side Door Guard
Safety switches are located on each guard. If a guard is opened while
the machine is running, the machine stops and the operator interface
indicates which door is open.
Guard design is based on level machine footings that are even with the
work area. Raising the machine or using platforms, staircases, stools,
or ladders near the machine creates hazardous operating conditions.
Guards shield personnel from moving parts. Reaching over, under, or
through a guard, blocking it open, or tampering with a guard interlock
is extremely hazardous and must never be attempted. Guards should
never be altered from factory setup.
Work with special care when guards are removed for lubrication,
adjustment, and part replacement. All guards should be reinstalled cor-
rectly immediately following maintenance or repair.
Opening a guard does not disconnect electrical power in the control
cabinet. To disconnect control power, padlock the main disconnect in
the Off position.
• Machine location must provide sound footing, adequate
lighting, and accessibility from all sides.
• Do not install the machine in a combustible environment or
near combustible or explosive material.
• Keep the area around the machine clean and free of obsta-
cles to avoid injuries due to falls.
Never touch or repair components while they are hot. If heat compo-
nents must be handled, use insulated gloves and mechanical devices
where practical.
H A Y S S E
Figure 1: Machine Guards
NSA N D I AC R E ®
Front Door Guard
U l t i m a S V