Table of Contents
Advertisement
Servo Actuator Jaw
1 1 - 4 8 / R e v 1 5
1. Loosen the hex nut to open the fixture.
2. Place the bottom half of the fixture under the carrier
shaft and the drive link.
3. Place the top half of the fixture on top of the carrier
shaft and the drive link.
4. Tighten the hex nut to lock the drive link in the hor-
izontal (jaw closed) position.
c.
Place Drive Link Angle Fixture in position behind
the Front Drive Link Assembly as shown in the
above drawing.
d.
Rotate the Front Drive Link Assembly to contact the
angle surface on Drive Link Angle Fixture.
e.
Tighten the four (4) bolts on the bottom of both the
Front Drive Linkage Assemblies.
f.
Remove the Drive Link Angle Fixture and the Hori-
zontal Lock Position Fixture from the assembly.
H A Y S S E
NSA N D I AC R E
®
U l t i m a S V
Hide quick links:
Advertisement
Table of Contents
