HayssenSandiacre Ultima SV 12-19HR Instruction Manual page 213

2 Each Fixtures Required
1 = Actuator, Belt Drive Assembly
2 = Output Shaft
U l t i m a S V
Figure 24: Shaft Alignment Fixture
a. Place two (2) fixtures on to the shafts as shown below.
Adjust the output shaft position as needed to fit the
fixtures on to the shafts.
4
3
4
3 = Shaft
4 = Shaft Alignment Fixture (2 required)
Figure 25: Shaft Alignment Fixture Setup
b. Tighten bolts to the Support Brackets on the Output
Shaft.
Two(2) brackets with two (2) bolts on each bracket. Access the bolts
from underneath the support plate.
c. Remove both Shaft Alignment Fixtures from the
assembly.
H A Y S S E NSA N D I AC R E
1
2
®
11
1 1 - 4 5 / R e v 1 5