Table of Contents
Advertisement
U l t i m a S V
10.Remove the guard standoff.
a.
Remove one (1) guard support standoff from the sup-
port plate #1.
It is in front of the rear drive link assembly #25A on the non-motor side
of the assembly.
1
1 = Drive Motor
Figure 38: Guard Standoff Removal
11.Remove the three (3) drive belts.
a.
Lift the pulleys # 24 off of the bottom half of the sup-
port bracket assembly and move forward toward pul-
leys #23.
b.
Slide drive belt 1 # 12 off of the drive motor pulley #
22.
c.
Slide the three (3) drive belts off of the assembly by
lifting pulleys # 24 as needed.
d.
Slide all three (3) drive belts off of the output shaft
pulleys # 23. Pivot and lift the output shaft assembly
as needed to remove the drive belts.
e.
Remove the three (3) drive belts from the assembly.
12.Install the new drive belts.
a.
Slide all three (3) drive belts onto the output shaft pul-
leys # 23. Pivot and lift the output shaft assembly as
needed to install the drive belts.
b.
Slide drive belt 1 # 12 onto the drive motor pulley #
22
c.
Slide two (2) drive belts onto the pulleys # 24 lifting
as needed to install.
d.
Lift the pulleys # 24 and place them on the bottom
half of the support bracket assembly #20.
H A Y S S E
NSA N D I AC R E
2 = Rear Drive Link Assembly
®
11
2
3
3 = Standoff
1 1 - 5 9 / R e v 1 5
Hide quick links:
Advertisement
Table of Contents
