Delta ASD-A2-0121 Series User Manual page 507

Chapter 8 Parameters
P5-91 CMAN E-CAM: AREA No. - The Point of DO OFF
Operational
Interface：
Default： 360
Control
Mode：
Range： 0 ~ 360
Data Size： 16-bit
Format： Decimal
Settings： When E-cam is engaged, set the end angle of DO output (DO.
P5-92 PLED
Operational
Interface：
Default： 0
Control
Mode：
Range： -2147483648 ~ +2147483647
Data Size： 32-bit
Format： Decimal
Settings： Version V1.006 sub04 (included or after):
8-208
Panel / Software
PR
Unit： Degree (It was changed after firmware
V1.009)
CAM_AREA).
Note: A2-L does not support E-cam function.
E-CAM: Pre-engaged Time of Each Cycle
Panel / Software
PR
Unit： -
This parameter goes with the selection of P5-88, U=4 (E-cam will
disengage if it exceeds the moving distance):
After disengaging, it does not enter the Stop status but pre-engaged
status. The lead pulse is determined by this parameter.
Communication
Communication
ASDA-A2
Address: 05B6H
05B7H
Related Section:
7.11
Address: 05B8H
05B9H
Related Section:
7.11