Delta ASD-A2-0121 Series User Manual page 356

ASDA-A2
P1-22 SPF1
Operational
Interface：
Default： 0x0000
Control
Mode：
Range： 0x0000 ~ 0x107F
Size：
Format： Hexadecimal
Settings：YX: Acceleration time limit (0: Disabled, [1~127] x 10 ms). Units: 10 ms
PR Special Filter Settings
Panel / Software
PR
Unit： -
Data
16-bit (format = UZYX)
Z: Reserved
U: Reverse inhibit (0: Disabled; 1: Enabled)
YX: The acceleration time limit is 0 ~ 1270 ms. When the changes of PR
(or E-Cam) commands are too fast, it will cause the vibration of the
mechanical system and affect the system performance. This
function can be used to control the acceleration (deceleration)
speed without exceeding the limit and can smooth the operation,
reduce the noise and extend the system life.
This function is different from the general filter. The traditional one
filter the command regardless the command change. This causes
the delay of command delivered and reduces the efficiency of the
system. This function can help to disable the filter function when the
command changes within the limit. Then, the commands can be
delivered without any time delay. The definition of this setting is the
required acceleration time when the motor runs from 0 to
3000 r/min. The required time is longer, the effect of the filter
function is better and the acceleration / deceleration will become
smoother.
Note:
The unit of acceleration time limit is 10 ms. For example, if YX=12h,
the acceleration time limit is 180 ms. It means the filter function is
enabled when the acceleration or deceleration time is faster than
180 ms. Otherwise, the command will remain unchanged.
Communication
Chapter 8 Parameters
Address: 012CH
012DH
Related Section:
8-57