Delta ASD-A2-0121 Series User Manual page 125

Chapter 3 Wiring
3-60
(3) Leave a length of 5 - 10 mm
(0.2 - 0.39 inches) metal core wires with
shielding outside of the cable. The
length is about the width of the metal
saddle. The other unexposed wires of
the cable should be protected by heat
shrink tube for good ground contact.
(4) Install a metal saddle to fix the exposed
metal core wires. The metal saddle
must completely cover all the exposed
metal core wires. The extended sheet
metal should be connected to the metal
part of the connector.
(5) Install the connector with shielding into
the plastic case as shown in the figure.
(6) Tighten the screws to complete a
shielded CN2 connector.
ASDA-A2