Delta ASD-A2-0121 Series User Manual page 499

Chapter 8 Parameters
P5-79■ CSDS
Operational
Interface：
Default： 0
Control
Mode：
Range： -2147483648 ~ +2147483647
Data Size： 32-bit
Format： Decimal
Settings： When synchronous capture axis is operating, the synchronous error
P5-80 CSDS
Operational
Interface：
Default： 10
Control
Mode：
Range： 0 ~ 90
Data Size： 16-bit
Format： Decimal
8-200
Error Pulse Number of Synchronous Capture
Axis
Panel / Software
ALL
Unit： Pulse unit of capture axis
should be 0. This parameter shows this error value. The followings are
its concept:
Synchronous Error ＝ Output value of synchronous axis－Setting
When capturing the data, the synchronous axis works normally. This
parameter updates once.
This parameter can be written into as well. It indicates the offset of
synchronous master. When the synchronous capture axis is regarded
as the master of flying shear, modify this parameter can deviate the
cutting position to the left/right.
Note: A2-L does not support E-Cam function.
Max. Correction Rate of Synchronous Capture
Axis
Panel / Software
ALL
Unit： %
Communication
value of synchronous axis
＝ the accumulative amount of P5-77－(P5-78 x
Capturing number of times)
Communication
ASDA-A2
Address: 059EH
059FH
Related Section: -
Address: 05A0H
05A1H
Related Section: -