User Interface - Siemens XC10 Series Installation, Commissioning Maintenance

Overview
4.6

User interface

1 System ON
Silence
2 Re-sound
Fault
Sounders
3
Power supply
4
System fault
Silence
5
Earth fault
buzzer
6 Disable
7
Detector test
8
Fire alarm Reset
9 Remote transmission
10
Operating access
1 2 3
Indicators
State
N° Color
1 Green Fixed
2 Yellow Fixed
Fast
3 Yellow Slow
Fast
4 Yellow Fixed
Slow
5 Yellow Fast
6 Yellow Fixed
7 Yellow Slow
8 Red Fixed
9 Red Fixed
10 Yellow Fixed
Slow
11 Yellow Fixed
12 Yellow Fast
13 Yellow Fast
18
Building Technologies
Fire Safety & Security Products
All display and control elements, except 4-digit display for XC1001-A and XC1003-A
versions, are accessible to the user:
- Led 1 to 32 indicators for operating condition,
- Keys 1 to 15 allowing :
operating access
operation (reset, off, test, etc)
system test
user functions programming
- 4-digit display showing:
programming steps and options
pre-warning time count down
other information's (calibration states, alarm counter, etc)
11
Mechanical blocked
5
12 Incorrect status
13
Loss of agent
14 Manual blocked
6
15
16
Automatic blocked
17
Activated
7
18 Released
19 Sounders
20
Actuators
21
Fire controls
22
RT-fault
4
23
RT-alarm
Fig. 6 XC10xx-A, user interface
Description
The control panel is in operation
The control panel is not able to function any more
Fault on at least one component in the system (see paragraph 14.2 for the detail)
Mains fault
Batteries fault
Microprocessor fault
Jumper buzzer (X3 - XCM1002 board) not connected (remainder)
At least one component connected to the control panel is grounded
At least one component in the system is disabled
–
Calibration in progress or error
–
– Programming in progress
At least one detection zone and/or extinguishing manual control is being tested
At least one detection zone is in alarm
Remote transmission activated (*)
Level 2 operating access granted
System test activated
Mechanical blocking device is in the blocked position
Mechanical blocking device is in a wrong position
–
Selector valve is in a wrong position (used for multi-sector applications)
–
Loss of agent
(*) According to programming
24 25
Detector Zone 1
Emergency
........................................
hold 26
27
Detector Zone 2
8
Mode
..........................................
28
29
Detector Zone 3
9
Led test
..........................................
30
31
Disable
10
Manual release
Enable
32
Disable
11
Enable
Disable
12 2
Test
Enable
Disable
13
Test
Enable
Disable
14
Test
Enable
Disable
15
Test
Enable
A6V10257473_b_en_--.doc
01.2010