Table of Contents
Advertisement
Programming LOGO!
3.8 Configuring additional functions for LOGO! (0BA7 only)
8. Press
9. Press . LOGO! displays the third screen form for gateway address setting. The default
Transferring the circuit program to LOGO!Soft Comfort
After you have finished the network settings, you transfer the circuit program from LOGO! to
LOGO!Soft Comfort using the transfer command LOGO!→PC in LOGO!Soft Comfort. For
further information on uploading the circuit program to LOGO!Soft Comfort with this transfer
menu command, refer to the Online Help for LOGO!Soft Comfort V7.0.
3.8.2
Configuring a UDF (User-Defined Function)
You can configure UDF (User-Defined Function) blocks only from LOGO!Soft Comfort.
A UDF block is a preconfigured circuit program that you create in LOGO!Soft Comfort. You
can add it to an existing circuit program as you do with a function block. For a detailed
description of the UDF configuration in LOGO!Soft Comfort, refer to the online help for
LOGO!Soft Comfort V7.0.
If your circuit program in LOGO! contains a UDF block, you can configure elements
connected to the block. For more information of configuration of UDF elements from LOGO!
0BA7, refer to the topic UDF (User-Defined Function) (0BA7 only) (Page 279).
120
or
to step into the next screen form for subnet mask setting. The default
subnet mask is as shown below. To change the setting, press OK. When the cursor
appears in a solid square, press
to modify the number, then press
your change, press OK.
gateway is as shown below. To change the setting, press OK. When the cursor appears
in a solid square, press
the number, then press
change, press OK.
or
to move the cursor to a position where you want
or
to increase or decrease the number. To confirm
or
to move the cursor to a position where you want to modify
or
to increase or decrease the number. To confirm your
Manual, 04/2011, A5E03556174-01
LOGO!
Advertisement
Chapters
Table of Contents
